-
The process of the droplet impact onto the liquid film, as one of the basic multiphase problems, is very important in many fields of science and engineering. On the other hand, the problem is also very complicated since there are many parameters that may influence the process of the droplet impact on the liquid film. To clearly understand the physical phenomena appearing in the process droplet impact on the liquid film, a parametric study on this problem is conduced based on a recently developed lattice Boltzmann method in which a lattice Boltzmann model is used to solve the Navier-Stokes equations, and the other is adopted to solve the Cahn-Hilliard equation that is used to depict the interface between different phases. In this paper, we mainly focus on the effects of the Reynolds number (Re), the Weber number (We), the relative thickness of film (h) and the surface tension () on the dynamic behavior of interface between different phases, and the velocity and pressure fields are also presented. It is found that with the increase of Re and We, the phenomena of crown and entrainment can be observed obviously during the process of droplet impact onto the liquid film, and the radius of the crown seems not dependent on the We and Re where the relative thickness of film and surface tension are fixed to be 0.5 and 0.003. However, when Re becomes much larger, the splashing phenomenon is produced, and the small droplets caused by the splashing can fall and then impact onto the liquid film again. We also find that if the relative thickness of film is small, the surface tension, Re and We are set to be 0.003, 480 and 500, the film can break up during the process of the droplet impact onto the liquid film, while with the increase of relative thickness, although more liquid are induced in the splashing process, the film cant break up. In addition, with the increase of surface tension, the resistance which prevents the change of interface becomes large, and thus the change of interface is not large when the droplet impacts onto liquid film, as expected. And finally, a quantitative study on the relation between the radius of crown (formed by droplet impact onto liquid film) and the time is also performed, and the expression r/(2R) Ut/(2R) where the parameter is about 1.0 and is also independent of We and Re, can be used to describe the relation.
-
Keywords:
- lattice Boltzmann method /
- droplet /
- liquid film
[1] Yarin A L 2006 Annu. Rev. Fluid Mech. 38 159
[2] Rioboo R, Tropea C, Marengo M 2001 Atom. Sprays 11 155
[3] Thoroddsen S T 2002 J. Fluid Mech. 451 373
[4] Yarin A L, Weiss D A 1995 J. Fluid Mech. 382 141
[5] Wang A B, Chen C C 2000 Phys. Fluids 12 2155
[6] Mohamed-Kassim Z, Longmire E K 2003 Phys. Fluids 15 3263
[7] Guo J H, Dai S Q, Dai Q 2010 Acta Phys. Sin. 59 2601 (in Chinese) [郭加宏, 戴世强, 代钦 2010 59 2601]
[8] Weiss D A, Yarin A L 1999 J. Fluid Mech. 385 229
[9] Lee S H, Hur N, Kang S 2011 J. Mech. Sci. Tech. 25 2567
[10] Xie H, Koshizuka S, Oka Y 2004 Int. J. Numer. Meth. Fluids 45 1009
[11] Coppola G, Rocco G, Luca L D 2011 Phys. Fluids 23 0022105
[12] Josseranda C, Zaleskib S 2003 Phys. Fluids 15 1650
[13] Berberovi E, Hinsberg N P V, Jakirli S, Roisman I R, Tropea C 2009 Phys. Rev. E 79 036306
[14] Liang G T, Guo Y L, Shen S Q 2013 Acta Phys. Sin. 62 024705 (in Chinese) [梁刚涛, 郭亚丽, 沈胜强 2013 62 024705]
[15] Wang Y, Shu C, Huang H B, Teo C J 2015 J. Comput. Phys. 280 404
[16] Lee T, Lin C L 2005 J. Comput. Phys. 206 16
[17] Li Q, Luo K H, Gao Y J, He Y L 2012 Phys. Rev. E 85 026704
[18] Lee T, Liu L 2010 J. Comput. Phys. 229 8045
[19] Rieber M, Frohn A 1999 Int. J. Heat Fluid Flow 20 445
[20] Hai Q X, Zhong Z, Liang Q Z 2016 Chin. Phys. B 25 014702
[21] Song B W, Ren F, Hu H B, Huang Q G 2015 Chin. Phys. B 24 014703
[22] Chai Z H, Zhao T S 2012 Acta Mech. Sin. 28 983
[23] Liang H, Shi B C, Guo Z L, Chai Z H 2014 Phys. Rev. E 89 053320
[24] Huang J J, Huang H, Wang X 2015 Int. J. Numer. Meth. Fluids 77 123
-
[1] Yarin A L 2006 Annu. Rev. Fluid Mech. 38 159
[2] Rioboo R, Tropea C, Marengo M 2001 Atom. Sprays 11 155
[3] Thoroddsen S T 2002 J. Fluid Mech. 451 373
[4] Yarin A L, Weiss D A 1995 J. Fluid Mech. 382 141
[5] Wang A B, Chen C C 2000 Phys. Fluids 12 2155
[6] Mohamed-Kassim Z, Longmire E K 2003 Phys. Fluids 15 3263
[7] Guo J H, Dai S Q, Dai Q 2010 Acta Phys. Sin. 59 2601 (in Chinese) [郭加宏, 戴世强, 代钦 2010 59 2601]
[8] Weiss D A, Yarin A L 1999 J. Fluid Mech. 385 229
[9] Lee S H, Hur N, Kang S 2011 J. Mech. Sci. Tech. 25 2567
[10] Xie H, Koshizuka S, Oka Y 2004 Int. J. Numer. Meth. Fluids 45 1009
[11] Coppola G, Rocco G, Luca L D 2011 Phys. Fluids 23 0022105
[12] Josseranda C, Zaleskib S 2003 Phys. Fluids 15 1650
[13] Berberovi E, Hinsberg N P V, Jakirli S, Roisman I R, Tropea C 2009 Phys. Rev. E 79 036306
[14] Liang G T, Guo Y L, Shen S Q 2013 Acta Phys. Sin. 62 024705 (in Chinese) [梁刚涛, 郭亚丽, 沈胜强 2013 62 024705]
[15] Wang Y, Shu C, Huang H B, Teo C J 2015 J. Comput. Phys. 280 404
[16] Lee T, Lin C L 2005 J. Comput. Phys. 206 16
[17] Li Q, Luo K H, Gao Y J, He Y L 2012 Phys. Rev. E 85 026704
[18] Lee T, Liu L 2010 J. Comput. Phys. 229 8045
[19] Rieber M, Frohn A 1999 Int. J. Heat Fluid Flow 20 445
[20] Hai Q X, Zhong Z, Liang Q Z 2016 Chin. Phys. B 25 014702
[21] Song B W, Ren F, Hu H B, Huang Q G 2015 Chin. Phys. B 24 014703
[22] Chai Z H, Zhao T S 2012 Acta Mech. Sin. 28 983
[23] Liang H, Shi B C, Guo Z L, Chai Z H 2014 Phys. Rev. E 89 053320
[24] Huang J J, Huang H, Wang X 2015 Int. J. Numer. Meth. Fluids 77 123
Catalog
Metrics
- Abstract views: 7762
- PDF Downloads: 397
- Cited By: 0
下载:
