Inorganic CsPbIBr ₂perovskite has been considered as a promising light-absorbing material for solar cells due to its high stability and suitable bandgap. Although the remarkable improvement of CsPbIBr ₂PSC has been achieved, the efficiency of this cell is still lower than those of other analogues and far below its theoretical limit. This is mainly due to the serious charge recombination in the as-fabricated CsPbIBr ₂cells derived from the poor-quality CsPbIBr ₂perovskite film with a large quantity of defects and numerous grain boundaries. Therefore, fabricating high-quality CsPbIBr ₂perovskite film is a key factor for the further efficiency improvement of CsPbIBr ₂PSCs. Herein, phenylthiourea (PTU) additive is introduced into the CsPbIBr ₂precursor to tailor the crystallization of CsPbIBr ₂perovskite for fabricating high-quality CsPbIBr ₂perovskite. The C=S group of PTU can coordinate with PbBr ₂in the precursor owing to the lone-pair electrons on S and the empty orbits of Pb ²⁺. The strong interaction between PTU and the CsPbIBr ₂precursor components can form PTU·Pb···Br(I) intermediate phase in the precursor upon PTU introduction. The PTU·Pb···Br(I) intermediate phase can reduce the nucleation rate of perovskite and modulate the perovskite crystal growth because the extra energy is required to break the strong coordination bond in the intermediate phase, resulting in a low crystallization rate of CsPbIBr ₂perovskite. Such a retardation of perovskite crystallization is conducive to the formation of high-crystallinity perovskite film with smooth surface, large crystal grains, high crystallization, and low density of defect. Meanwhile, the decomposition of PTU during thermal annealing makes the S ^2–inserted into interstitial of CsPbIBr ₂crystal lattice, which greatly enhance the stability of CsPbIBr ₂perovskite. The carbon-based PSCs with a normal n-i-p structure of FTO/compact-TiO ₂layer/meso-TiO ₂layer/perovskite film/carbon layer are fabricated, and their photovoltaic performances are measured under a simulated AM1.5 illumination (100 mW·cm ^–2). The PSC based on PTU-CsPbIBr ₂perovskite delivers a high power conversion efficiency of 10.09%, which is much higher than that of the control device. This great improvement of photovoltaic performance can be attributed to the largely promoted perovskite quality, which enhances the charge collection and suppresses the charge recombination in the device. In addition, the unencapsulated device preserves 82% of the initial efficiency after being stored under ambient condition for 35 days, suggesting excellent stability. Therefore, this work provides an effective complementary strategy for effectively improving the performance of inorganic PSCs.